Air compressor pipeline installation should pay attention to what matters? Small make up words: air compressor piping installation if the connection is bad, turning too much,too, diameter of improper selection, will cause the leakage and pressure loss.
Air compressor pipeline installation should pay attention to what?
First, must according to the length of pipe and compressed air requirement to select the appropriate diameter; minimize the attachment, acute angle and rotation(especially to avoid sharp corners); and in the same line, do not allow installation ofpipes of different diameter discontinuity. Try to reduce or not use rubber hose(because the resistance); pipe connection should be firm, sunscreen, antifreezemeasures should, do not allow the local water; pipe shall not be laid in the near fire,corrosion and blasting, and power line should be a safe distance, and shall notprevent the traffic and construction; every 60 meters should be equipped with flexiblejoint (expansion and contraction of pipe to prevent damage); main gas pipe every 500 meters, should be provided with a water separator in hollows, and discharge water in accordance with the provisions of.
Another very important point is, must according to air consumption choice of pipe diameter of the corresponding. Because of the compressed air in the flow, and wallfriction resistance, pipe diameter is small, the friction resistance increases, the pressure loss of compressed air is also bigger, will increase the power consumption ofair compressor.
Reminder.
Chronicles and the electromechanical device limited company to recommend air compressor, water heater, air compressor heat recovery equipment, as long as youhave the air compressor factory, can 0 operation cost of producing hot water andheating.
See details > >
(this paper mainly introduces the air compressor piping installation, but in actual in the problem solving process is for reference only.) |