中文版   English  
 
News Center
 · Strengthen the three dialectic
 · Let mobile compressor run fast
 · Polyurethane insulation cotton
 · Air to water heater industry -
 · Vacuum drying box using the pr
 · Heat pump quality guarantee "c
 · Air compressor motor protectio
 · Water pump
Contact Us
  • Address:Qinghu cun, Qishi Town, Dongguan, Guangdong Province
    Contact Person:Mr Yan
    E-Mail:zhihe998@126.com
    Tel:+86-0769-86723636
    Fax:+86-0769-81080026
    Mobile:13829228807  
               13829282260
    QQ:2463307187    
    WebSite: www.dg-zhihe.cn

 
News Center Location: Home > News
 

Air compressor after treatment
Author: 志和      Release Date:2014/4/16      View Count:1602
 

Air compressor is usually produced by compressed air contains a certain amount of lubricating oil, and there is a certain amount of water, but some places are prohibitedoil and water cut (especially for food products industry). We should not only pay attention to the type of compressor, but also need to increase after treatment equipment.

Can do without gas compressor lubricating oil is not, can not do without water. We can divide the air compressor and a grade two or purifying device or dryer, this device can make the compressed air without oil is not moisture, so that the compressed air of the oil content is reduced in a certain extent.

Keep the compressed air drying, the degree of purification due to customer requirements to allow different, choose different. Sequential allocation scheme usuallyuser: compressor + gas tank + FC centrifugal oil-water separator (pre) + refrigeration dryer + FT main line filter +FA - oil mist filter + (adsorption dryer + FT + FH active carbon deodorizing filter).

The gas tank: because of pressure vessel, safety accessories for the safety valve,pressure gauge, the drain valve should be complete. Exhaust volume in 2 to use the following 4m3/min 1000L storage tank; exhaust volume in the 6 ~ 10m3/min below1500L ~ 2000L storage tank.

FC centrifugal oil-water separator: can completely filter 3 or more solid state ion,remove 99% of water, 40% of the oil mist, oil content: 1 - 3PPM;

Freeze dryer: use the refrigerant heat exchange with compressed air, compressed air temperature dropped to 2 ~ 10  range of dew point temperature, the compressiontends super saturated moisture in the air, thereby removing a set of drying equipment,the compressed air in the water.

F T the main pipeline filter: filter can complete 1 or more solid state ion, not only can100% to remove moisture, but also can get rid of oil mist, about 70% of theatmospheric dew point: 23 , oil content: 1PPM;

FA - oil mist filter: micro glass fibre density, diameter and surface treatment of special design, solid particle filters 0.01 μ. External sponge layer absorption and discharge of oil mist, oil mist removal 99.999%

Adsorption dryer: for the removal of compressed air contains water

FH active carbon deodorizing filter: solid particle filters 0.01 μ. External sponge layer absorption and discharge of oil mist, residual oil rate of 0.003ppm

Reminder.

Chronicles and the electromechanical device limited company to recommend air compressor, water heater, air compressor heat recovery equipment, as long as youhave the air compressor factory, can 0 operation cost of producing hot water andheating.

See details > >

(this paper mainly analyzes the air compressor after treatment, but in actual in the problem solving process is for reference only.)

 
专业提供:空压机热水器空压机余热回收空压机余热利用空气能热水器系列
Address:Qinghu cun, Qishi Town, Dongguan, Guangdong Province Tel:+86-0769-86723636 Fax:+86-0769-82820762
All rights reserved © DongGuan ZhiHe Mechanical and electrical equipment Co., LTD   
网站地图    sitemaps