中文版   English  
 
News Center
 · Strengthen the three dialectic
 · Let mobile compressor run fast
 · Polyurethane insulation cotton
 · Air to water heater industry -
 · Vacuum drying box using the pr
 · Heat pump quality guarantee "c
 · Air compressor motor protectio
 · Water pump
Contact Us
  • Address:Qinghu cun, Qishi Town, Dongguan, Guangdong Province
    Contact Person:Mr Yan
    E-Mail:zhihe998@126.com
    Tel:+86-0769-86723636
    Fax:+86-0769-81080026
    Mobile:13829228807  
               13829282260
    QQ:2463307187    
    WebSite: www.dg-zhihe.cn

 
News Center Location: Home > News
 

The reason of air compressor cylinder overheating and Solutions
Author: 空压机热水器      Release Date:2013/12/30      View Count:2537
 

The reason of air compressor cylinder overheating is mainly concerned with the cooling and lubricating, below we explain the common causes and solutions:
The 1 suction temperature is too high
Solution: reduce the suction temperature.
The 2 gas exhaust valve leakage
Solution: to determine which only valve should be replaced after valve parts.
3 inner cooling water jacket, cylinder deficiency
Solution: cooling water supply can be increased properly.
Too much sediment water jacket in 4, attached to the cylinder wall effect of cooling, cooling pipe
Solution: cleaning the cylinder and the cylinder liner and the cooler.
The piston rod 5 motion mechanism of bending, so that the piston in the cylinder does not exceed the prescribed by the verticality of the piston and cylinder surface tilt, friction heat
Solution: adjust the piston assembly and cylinder concentric, if the piston rod bending shall repair or replace.
6 two cylinder overheating, may be intermediate cooler water, composed of a cylinder compressed air without cooling, or intermediate cooler cooling is not good
Solution: cooling water cut off immediately after the stop for inspection, to be cooling after the drive cylinder.
The 7 piston assembly deviation in the cylinder or cylinder exacerbate friction in lack of oil caused by dry friction
Solution: check the lubrication system appropriate to adjust the amount of oil.
8 cylinder clearance volume is too small, so that the bottom dead center of the compression ratio is too large or cylinder clearance in high pressure, residual gas in a cylinder is overmuch, caused by temperature rise of cylinder
Solution: adjust the cylinder bottom dead center gap, kept in a specified standard.

 
专业提供:空压机热水器空压机余热回收空压机余热利用空气能热水器系列
Address:Qinghu cun, Qishi Town, Dongguan, Guangdong Province Tel:+86-0769-86723636 Fax:+86-0769-82820762
All rights reserved © DongGuan ZhiHe Mechanical and electrical equipment Co., LTD   
网站地图    sitemaps