Energy conservation of air compressor mainly in the following ways:
One, the centralized control method
On the compressor adopts centralized control mode. According to the gas automatic control of air compressor running numbers, before reconstruction, air compressor opening number is fixed.
If the volume is further reduced, and good performance of the compressor can be stopped automatically. Energy conservation of air compressor, can stop the corresponding number of air compressor, running numbers were reduced, will undoubtedly saving electricity.
When the gas is reduced to a certain amount, air compressor is adopted to reduce the loading time to reduce the gas production.
Two, variable speed control system
Adopt frequency conversion method to reduce air compressor motor power output shaft. Before reconstruction, air compressor pressure reaches the set pressure, that will automatically unloading; after the transformation, air compressor is unloaded, but by reducing the rotating speed to reduce the compressor gas production, maintenance of gas network requires a minimum pressure. There are two places to energy saving:
Reduce compressor from the unloading state to the loaded state of this mutation process brought about by electric energy consumption.
Motor operation frequency is reduced to power following, the motor shaft output power reduction. The above two ways are reduced in different degree of the air compressor in the process of operation energy consumption, but the air compressor in the work process generated so much heat and make it white diffused into air, but in a very long time did not get user attention, this cannot say not a great pity.
Through a lot of research and testing, in the earliest developed can make full use of air compressor energy water heater, received wide acclaim from all sectors of society.
Three, air compressor waste heat recovery
Air compressor heat recovery is a very environmentally friendly energy-saving way. And the air compressor water heater working principle: air compressor oil high temperature via heat exchangers to transfer heat to the cooling water, the cooling water is heated to flow to the heat insulation water storage bucket, so that we can achieve the purpose of air compressor waste heat recovery.